Equipment

The MicroClean cleaning system cleans dentures automatically, gently, and in a way that is appropriate for the material involved. Even the strongest contaminants such as plaque and tartar can be automatically removed by MicroClean without any difficulty. Even in difficult to reach areas. No matter whether it is a denture that the patient has already worn or a newly made one - MicroClean cleans, polishes and pre-polishes e.g. crowns or bridges quickly and without material abrasion right into the finest inter-dental areas, fissures and telescopic tips. Benefits: Perfect automatic cleaning Especially for difficult, difficult to access areas (e.g. load distribution clasp) Top quality surface conditioning without any frictional loss! (telescopic restorations) Easy removal of fixing cement Makes ultrasonic cleaning unnecessary Significantly more efficient work, free from interruptions Basic equipment: Needles long, 150 g Plastic container Tweezers, 18 cm Holding magnet, complete Stand-up display Measuring cylinder, 50 ml 2 x 500 ml cleaning fluid (green and orange) Technical Data: Voltage: 230 V~ Power output: 200 VA Speed: 1450 rpm Number of phases: 1 phase-N+PE Neutral conductor: loadable N~  Protective conductor: separate protective conductor (PE green/yellow) Protection class: I Protection type: covered Frequency: 50/60 Hz Noise level: < 65 dB (A) Dimensions (w x d x h): 185 x 175 x 195 mm Weight: 7 kg

Reduction of residual monomer - by means of secondary treatment of cold curing prostheses. Allergic reactions and sensitivities because of newly produced dental prosthesis with acrylic parts become more and more common. They pose a real problem for the wearer. Within 16 hours, Schütz Dental's Monomer Extractor can reduce the residual monomer in denture acrylics from more than 4.5 % to less than 0.4 %* in many cases. Your benefits: Irritations of the palate and a burning sensation in the mouth are avoided almost completely. Increased wearing comfort of the prosthesis. Allergic reactions are reduced significantly. No additional workload. The procedure runs automatically over night. This secondary treatment can be billed to the patient in some cases. Decreases the residual monomer content  from more than 4.5 % to less than 0.4 %* duing a 16 hour temperature-controlled immersion in water and with an optional addition of active oxygen. *Depends on the acrylic material used. Tested by „GDF Gesellschaft für dentale Forschung und Innovationen GmbH“, Rosbach/Germany.

Made from stainless steel. For cold and heat polymerization at a pressure up to 2 kg/cm². Dimensions: Height: 235 mmWidth: 245 mmLength: 420 mmDiameter: 245 mmVolume: 6 lMaterial: stainless steelGewicht: 2406 g

Basket insert for Monomer Extractor for the reduction of residual monomer by secondary treatment of cold curing prostheses.

600 ml glass beaker for Monomer Extractor for the reduction of residual monomer by secondary treatment of cold curing prostheses.